Table of Contents
Advertisement
Using the Compression Terminal
To ground the CVX 1800 chassis using the compression terminal, follow these
steps:
Step
1
2
3
4
296-1011-200 Rel. 5.0, Doc. Rev. 08.01
Action
Locate a suitable ground cable at your facility.
On the back of the chassis, locate the posts in the lower left corner.
Remove 1/2 inch
of insulation from
the ground cable.
To facility ground
Use a 1/4-inch flat-tip screwdriver to loosen the locking screw.
Use a wire stripper to remove approximately 1/2 inch of insulation from the
ground cable.
Chassis Connections
Connecting Power to the Chassis
Turn counterclockwise
to loosen screw.
1/4-inch flat-tip
screwdriver
CVX-0062B
(continued)
3-23
Advertisement
Table of Contents
