Mounting Options
You can install the external AC power supply in any Telco or EIA 19-inch rack.
You can mount the power supply so that it is flush with the top or bottom of the
CVX 1800. Flush-mounting the power supply with the CVX 1800 chassis does
not obstruct airflow.
Procedure
To install the external AC power supply, follow these steps:
Step
1
2
3
4
5
296-1011-200 Rel. 5.0, Doc. Rev. 08.01
Installing the External AC Power Supply
Action
Locate a suitable position in a rack close to the CVX 1800 chassis.
Lift the power supply to the desired installation height.
Align the flange holes with the holes on the front vertical supports of the
(plastic fascia CVX chassis shown)
rack.
Insert a truss-head screw through each flange hole and into the
corresponding hole in the front vertical supports of the rack.
Use a Phillips screwdriver to tighten the screws.
Metal Fascia Chassis Installation
(continued)
1-25