CVX 1800 Hardware Installation Guide
Replacing Modules and Filler Panels
Replacing the DAC-LTM or DAC-RLTM
If you need to replace an LTM or RLTM, note the configuration of the installed
network cabling before you disconnect any cables. You will need to reinstall this
cabling on the replacement LTM or RLTM.
Caution: Before removing the LTM or RLTM, you must remove the
corresponding SMs.
References
For more information on removing the SM, see
page 4-15
Removing a DAC-LTM or DAC-RLTM
To remove a DAC-LTM or DAC-RLTM, follow these steps:
Step
1
2
4-36
or
"Replacing Other Service Modules"
Action
Disconnect any cables attached to the LTM or RLTM.
If you have not already done so, remove the corresponding SMs.
"Replacing the SCC-SM"
on
page
4-28.
296-1011-906 Rel. 5.0, Doc. Rev. 08.01
on