CVX 1800 Hardware Installation Guide
Connecting Power to the Chassis
Using the Loop Connectors
To connect the CVX 1800 to a DC power source using the loop connectors, follow
these steps:
Step
1
2
3
3-30
Action
Use a Phillips screwdriver to loosen the recessed, left-most screws on
the compression terminals, then remove the terminals from the chassis.
urn counterclockwise
o loosen screw.
Using the screws that you just removed, secure the loop connectors to
the lower screw holes. Use a Phillips or Robertson #2 screwdriver to
tighten the screws to 24 in-lb.
Turn clockwise
to tighten screw
to 24 in-lb.
Phillips or Robertson #2
screwdriver
Secure the cables using the cable mount on the lower right corner of
the chassis. The cables run between the two black insulators.
hillips or
obertson #2 screwdriver
296-1011-200 Rel. 5.0, Doc. Rev. 08.01
CVX-0117A
CVX-0070A