Table of Contents
Advertisement
CVX 1800 Hardware Installation Guide
Connecting Power to the Chassis
Options for Connecting to a DC Power Source
There are two ways to connect the CVX 1800 to a DC power source:
•
Use the compression terminals.
•
Use the loop connectors.
Using the Compression Terminals
To connect the CVX 1800 to a DC power source using the compression terminals,
follow these steps:
1
3-26
Use a 1/4-inch flat-tip or Robertson #2 screwdriver to loosen the locking
screws on the compression terminal labeled "A -48V" and one of the
compression terminals labeled "RTN."
Turn counterclockwise
to loosen.
It does not matter which RTN compression terminal you use. The RTN
compression terminals provide a common ground connection.
1/4-inch flat-tip or Robertson #2
screwdriver
296-1011-200 Rel. 5.0, Doc. Rev. 08.01
CVX_0069A
Advertisement
Table of Contents
