Table 27 Network > Wireless LAN 2.4G/5G > WPS (continued)
LABEL
Apply
Cancel
9.9 WPS Station Screen
Use this screen when you want to add a wireless station using WPS. To open this screen, click Network >
Wireless LAN 2.4G/5G > WPS Station.
Note: After you click Push Button on this screen, you have to press a similar button in the
wireless station utility within 2 minutes. To add the second wireless station, you have to
press these buttons on both device and the wireless station again after the first 2
minutes.
Figure 44 Network > Wireless LAN 2.4G/5G > WPS Station
The following table describes the labels in this screen.
Table 28 Network > Wireless LAN 2.4G/5G > WPS Station
LABEL
Push Button
Or input station's PIN
number
9.10 Scheduling Screen
Use this screen to set the times your wireless LAN is turned on and off. Wireless LAN scheduling is disabled
by default. The wireless LAN can be scheduled to turn on or off on certain days and at certain times. To
open this screen, click Network > Wireless LAN 2.4G/5G > Scheduling tab.
Chapter 9 Wireless LAN
DESCRIPTION
Click Apply to save your changes back to the EMG6765-Q10A.
Click Cancel to reload the previous configuration for this screen.
DESCRIPTION
Use this button when you use the PBC (Push Button Configuration) method to configure
wireless station's wireless settings.
Click this to start WPS-aware wireless station scanning and the wireless security information
synchronization.
Use this button when you use the PIN Configuration method to configure wireless station's
wireless settings.
Type the same PIN number generated in the wireless station's utility. Then click Start to
associate to each other and perform the wireless security information synchronization.
EMG6765-Q10A User's Guide
89