Wan Ip Address; Dns Server Address Assignment - ZyXEL Communications EMG6765-Q10A User Manual

Ac2200 gigabit ethernet moca gateway
Table of Contents

Advertisement

Ethernet) or PPTP (Point-to-Point Tunneling Protocol), they should also provide a username and password
(and service name) for user authentication.

WAN IP Address

The WAN IP address is an IP address for the EMG6765-Q10A, which makes it accessible from an outside
network. It is used by the EMG6765-Q10A to communicate with other devices in other networks. It can
be static (fixed) or dynamically assigned by the ISP each time the EMG6765-Q10A tries to access the
Internet.
If your ISP assigns you a static WAN IP address, they should also assign you the subnet mask and DNS
server IP address(es) (and a gateway IP address if you use the Ethernet or ENET ENCAP encapsulation
method).

DNS Server Address Assignment

Use Domain Name System (DNS) to map a domain name to its corresponding IP address and vice versa,
for instance, the IP address of www.zyxel.com is 204.217.0.2. The DNS server is extremely important
because without it, you must know the IP address of a computer before you can access it.
The EMG6765-Q10A can get the DNS server addresses in the following ways.
The ISP tells you the DNS server addresses, usually in the form of an information sheet, when you sign up.
1
If your ISP gives you DNS server addresses, manually enter them in the DNS server fields.
If your ISP dynamically assigns the DNS server IP addresses (along with the EMG6765-Q10A's WAN IP
2
address), set the DNS server fields to get the DNS server address from the ISP.
WAN MAC Address
The MAC address screen allows users to configure the WAN port's MAC address by either using the
factory default or cloning the MAC address from a computer on your LAN. Choose Factory Default to
select the factory assigned default MAC Address.
Otherwise, click Clone the computer's MAC address - IP Address and enter the IP address of the
computer on the LAN whose MAC you are cloning. Once it is successfully configured, the address will be
copied to configuration file. It is recommended that you clone the MAC address prior to hooking up the
WAN Port.
Chapter 8 WAN
EMG6765-Q10A User's Guide
61

Advertisement

Table of Contents
loading

Table of Contents