The Wps Station Screen - ZyXEL Communications AMG1302-T10A User Manual

Click Network > Wireless LAN > WPS. The following screen displays.
Figure 55 Network > Wireless LAN > WPS
The following table describes the labels in this screen.
Table 37 Network > Wireless LAN > WPS
LABEL
WPS Setup
Enable WPS
PIN Number
Generate
WPS Status
Release
Apply
Refresh

8.5 The WPS Station Screen

Use this screen to set up a WPS wireless network using either Push Button Configuration (PBC) or
PIN Configuration.
AMG1302-T10A User's Guide
DESCRIPTION
Select the check box to activate WPS on the Device.
This shows the PIN (Personal Identification Number) of the Device. Enter this PIN in the
configuration utility of the device you want to connect to using WPS.
The PIN is not necessary when you use WPS push-button method.
Click this to have the Device create a new PIN.
This displays Configured when the Device has connected to a wireless network using
WPS or Enable WPS is selected and wireless or wireless security settings have been
changed. The current wireless and wireless security settings also appear in the screen.
This displays Unconfigured if WPS is disabled and there is no wireless or wireless
security changes on the Device or you click Release to remove the configured wireless
and wireless security settings.
This button is available when the WPS status is Configured.
Click this button to remove all configured wireless and wireless security settings for WPS
connections on the Device.
Click this to save your changes.
Click this to restore your previously saved settings.
Chapter 8 Wireless LAN
109