Controls; Replacing Power Module - Invacare Storm4 Service Manual

Seat support
Seat depth in
cm
D=51
D=51
D=51
D=51
D=48
D=48
D=48
D=48
Recaro seat
Optimist seat
Removing mud guard
1. If possible, move seat to uppermost position.
2.
Loosen and remove two Allen screws (2) and washers.
3. Remove mud guard (1) from transmission mounting (3).
4. Storm4 X-plore: Take care of spacers (4).
5. Replace mud guard according to table above.
Installing mud guard
1. Install parts in reverse order.

6.9 Controls

6.9.1 Replacing power module

When replacing power module in connection with
remote, take into account final selection of drive
program as described in "Drive program selection
after component replacement".
CAUTION!
Any changes to drive program can affect driving
characteristics and tipping stability of mobility
device.
– Changes to drive program may only be carried
out by trained Invacare specialist providers.
– Invacare can only give warranty for safe mobility
device driving behavior - especially tipping
stability - for unaltered standard drive programs.
All power modules are delivered with standard drive
program. If you have made any customer-specific
modifications to drive program, they must be adapted
after installation of new power module.
1533060-M
Seat width in Mud guard long
cm RH
yes
W=38
yes
W=43
x
W=48
x
W=53
yes
W=38
yes
W=43
x
W=48
x
W=53
yes
x
Mud guard long Mud guard
LH short RH
yes x
yes x
x yes
x yes
yes x
yes x
x yes
x yes
yes x
x yes
• 8 mm socket wrench
• To adapt the drive program: programming
software or hand programming device and
system installation manual, available from
Invacare.
Removing power module
1. Remove rear shroud. See 6.8.1 Replacing rear shroud,
page 38.
2. Carefully note location of cable and connection locations
of various plugs. Either mark each plug and socket, or
take a photograph with digital camera.
3. Pull all plugs out of power module.
4. Loosen two nuts on power module.
5. Remove power module.
6. Replace power module.
Installing power module
1. Install parts in reverse order.
2. Plug all plugs into their old positions.
3. Select drive program. See 6.9.11 Drive program selection
after component replacement, page 45.
Service
Mud guard
short LH
x
x
yes
yes
x
x
yes
yes
x
yes
41