ABB i-bus KNX Product Manual page 62

®
ABB i-bus KNX
Device technology
Supplied state
The device is supplied with the physical address 15.15.255. The application is pre-installed.
The complete application can be reloaded if required. Downloads may take longer after a change of
application or a discharge.
Assignment of the physical address
The assignment and programming of the physical address are carried out in ETS.
The device features a Programming button
Programming LED
assigned the physical address or the
Download response
Depending on the PC which is used, the progress bar for the download may take up to one and a half
minutes before it appears due to the complexity of the device.
Cleaning
The voltage supply to the device must be switched off before cleaning. If devices become dirty, they can
be cleaned using a dry cloth or a cloth dampened with a soapy solution. Corrosive agents or solutions
must never be used.
Maintenance
The device is maintenance-free. In the event of damage (e.g. during transport and/or storage), do not carry
out any repairs.
60 2CDC508134D0202 | FCA/S 1.x.x.1
lights up after the button has been pressed. It switches off as soon as ETS has
button is pressed again.
for assignment of the physical address. The red