Parameter Distinction Between Long And Short Operation - Yes - ABB i-bus KNX Product Manual

®
ABB i-bus KNX
Commissioning
Parameter Distinction between long and short operation – Yes
3.2.4.2.2
If the option Yes has been selected with the parameter Distinction between long and short operation, the
following parameters appear in
Short operation -> Event 0
Long operation -> Event 1
<−−− NOTE
180 2CDC508134D0202 | FCA/S 1.x.x.1
Parameter window a: Switch
Input on operation
Options: open
Closed

Open: The input is opened with actuation.

Closed: The input is closed with actuation.
If a normally open contact is connected to the input, the option Closed should be selected; on a
normally closed contact the option Open should be selected.
Long operation after ...
Options: 0.6/0.8 s
1/1.2/1.5 s
2/3/4/5/6/7/8/9/10 s
, after which an operation is considered a "long" operation, is defined.
Here the time period T
L
Note
The remaining parameter descriptions can be found in
and short operation –
No, p. 173.
sensor, p. 171:
Parameter Distinction between long