Parameter Window A: Value/Forced Operation - ABB i-bus KNX Product Manual
Fan coil actuators fca/s
Hide thumbs
Also See for i-bus KNX:
- Product manual (257 pages) ,
- Product manual (49 pages) ,
- Product manual (152 pages)
Table of Contents
Advertisement
®
ABB i-bus
KNX
Commissioning
3.2.4.3
Parameter window a: Value/forced operation
This operating mode allows the sending of values of any data types.
This parameter window is visible if the option Value/forced operation has been selected in the parameter
Input a in
Maximum dead time
This parameter is fixed to a preset 250 ms.
The maximum dead time prevents unwanted multiple operations of the input, e.g. due to bouncing of the
contact.
Parameter window Enable inputs
What is the maximum dead time?
An edge change at the input is assessed with a maximum dead time (delay) value of 250 ms. This
time may vary from 0 ms to 250 ms.
Note
No further bouncing is possible.
a...c, p. 170.
FCA/S 1.x.x.1 | 2CDC508134D0202 181
Advertisement
Table of Contents
