Certification And Compliance; Csa Standards; Safety; Regulatory Information - Fluke DTX Series User Manual

Certification and Compliance

;
Conforms to relevant Australian standards
P
Conforms to relevant European Union
directives.
)
Listed by the Canadian Standards Association.

CSA Standards

CAN/CSA-C22.2 No. 1010.1-92 + Amendment 2: 1997 and
CAN/CSA-C22.2 No. 1010.1 2000 (2
Requirements for Electrical Equipment for Measurement,
Control, and Laboratory Use, Part 1: General
Requirements.

Safety

CAN/CSA-C22.2 No. 1010.1-92 + Amendment 2: 1997;
Overvoltage Category II, Pollution degree 2, 30 V.
nd
EN61010, 2 Edition, MEASUREMENT (Installation)
CATEGORY I, Pollution Degree 2 per IEC1010-1 refers to
the level of Impulse Withstand Voltage protection
provided. Equipment of MEASUREMENT CATEGORY I is
nd
edition) Safety
for measurements performed on circuits not directly
connected to mains.

Regulatory Information

This equipment generates, uses, and can radiate radio
frequency energy, and, if not installed and used in
accordance with the manual, may cause interference to
radio communications. It has been tested and found to
comply with the limits for a Class A digital device pursuant
to Part 15, Subpart J of the FCC rules, which are designed
to provide reasonable protection against such interference
when operated in a commercial environment. Operation
of the equipment in a residential area is likely to cause
interference, in which case the user, at his own expense,
will be required to take whatever measures may be
required to correct the interference.
Certification and Compliance
69