Fluke DTX Series User Manual page 45

Autotest on Coaxial Cabling
1 Attach coaxial adapters to the tester and smart remote.
2 Turn the rotary switch to SETUP, then select Coaxial.
Set the following on the Coaxial tab:
•
Cable Type: Select a list of cable types; then select the
cable type to be tested.
•
Test Limit: Select the test limit required for the job.
The screen shows the last nine limits used. Press
More to see other lists of limits.
3 Turn the rotary switch to AUTOTEST and turn on the
smart remote. Connect to the cabling, as shown in
Figure 18 or 19.
4 If a fiber module is installed, you may need to press
J
Change Media to select Coax as the media type.
P
5 Press on the tester or smart remote. To stop the test
at any time, press
6 The tester shows the Autotest Summary screen when
the test is complete (see Figure 20 on page 40). To view
results for a specific parameter, use
J
highlight the parameter; then press
7 To save the results, press
N
then press
If you turn off the main or remote unit while the
two units are connected through coaxial adapters,
the unit will turn on again.
Certifying Coaxial Cabling
I
.
A D
H
N
. Select or create a cable ID;
again.
Note
to
.
37