Fluke DTX Series User Manual page 26

DTX Series CableAnalyzer
Users Manual
The DTX-PLA001 universal permanent link adapter has a
removable personality module. These may be changed to
customize the adapter for different jack configurations.
To change the personality module, do the following (refer
to Figure 8):
1 Ground yourself by touching a grounded, conductive
surface.
2 Remove the link interface adapter from the tester.
3 Use your fingers to unscrew the screw on the
personality module.
4 Store the module in its original, static protection bag.
5 Put the new module in place and tighten the screw
with your fingers.
W
Caution
Tighten the screw snugly with your fingers
only. Do not overtighten. Doing so can damage
the module or the end of the cable.
18
F1 F2 F3
EXIT TEST
ENTER
SAVE
AUTO
SINGLE TEST SETUP
TEST
SPECIAL
MONITOR FUNCTIONS
TALK
Figure 8. Changing the Personality Module on
DTX-PLA001 Adapters
The optional DTX-PLCAL automated calibration kit lets you
calibrate your permanent link adapters to compensate for
physical changes that occur over time to the adapter's
cable and other components. Contact Fluke Networks for
more information.
Static sensitive
device
Personality
module
amd74f.eps