Testing for Network Connectivity
1
Select DHCP or Static mode and enter ping addresses in
Setup, as described in Table 4.
2
Connect to the network as shown in Figure 23.
3
Turn the rotary switch to
4
MONITOR; then select Network Connectivity or
Network Connectivity w/ PoE.
Press P. Figure 24 describes the network connectivity
5
results.
6
You can save the results in a new record or add them to
existing cable test results for the same link. To save the
results, press
again.
Figure 23. Network Test Connections
Verifying Network Service
N
. Create or select an ID; then press
N
amd17f.eps
45