Safety Screen Replacement - Jøtul GF 305 DV IPI Installation And Operation Instructions Manual

Safety Screen Replacement

DO NOT OPERATE THIS APPLIANCE WITH A DAMAGED OR
MISSING SAFETY SCREEN. SERIOUS BURNS MAY RESULT
FROM INADVERTENT CONTACT WITH THE GLASS PANEL
EVEN WHEN THE APPLIANCE IS NOT OPERATING. REPLACE
SCREEN WITH KIT NO. 157992.
Replacement Kit Contents
1. Safety Screen
2. Gasket, 1/8"x 5/16", self-adhesive
Tools Required
• 10 mm wrench
or socket
• Utility knife
• Safety glasses
• Work gloves
Installation
1. Disconnect power from the appliance.
2. Remove the door from the stove by lifting to
disengage the hinge bar from the hinge pins.
3. Place the door face down on a towel or carpet.
Gradually remove the six, M6 x 25 mm screen frame
bolts in a cross-alternating pattern.
Remove the damaged screen and original gasket.
4. Loosely apply the self-adhesive gasket material into
the door channel. Do not stretch the gasket. Trim any
excess material.
5. Position the new screen over the door opening,
overlapping the gasket.
4. Replace the cast iron screen frame. Install the
frame bolts and gradually tighten them in a cross-
alternating pattern.
Figure 17.10
Safety Screen Replacement
1. Door
2. Gasket
3. Safety Screen
4. Screen Frame
5. Door Shade
6. M6 x 25mm hex bolts, 6
139843_A GF 305 DV IPI 8/17
1
2
3
4
5
6
45