Jøtul GF 305 DV IPI Installation And Operation Instructions Manual page 27

Step 3.
• Engage the holes in Log 3 with the locators on Logs 1 and 2.
• Engage the hole in Log 4 with the locator on Log 2.
Set the end of Log 4 into the pocket in the rear corner of the burner base.
A
Step 4.
• Engage the hole in Log 5 with the adjacent locator in Log 3 shown in Step 3 photo.
Engage the slotted end of Log 5 with the pin on the rear firebox shelf shown in Step 3 photo.
• Engage the two holes in Log 6 with the locators on Logs 4 and 2 . |
• Use a tooth brush to sparingly spread rock wool tufts over the front area of the burner base.
Use fibers to hide the left corner bolt hole, "A".
PROPANE NOTE: Soot may develop with Propane fuel in minimum vent configurations.
Should soot occur, remove the rock wool.
Log 5 Locator pins
3
1
5
3
139843_A GF 305 DV IPI 8/17
4
Log 6 Locator pins
2
4
6
27