Table of Contents
Advertisement
11. Optional Equipment
Optional Wall Thermostat 750003
PLEASE NOTE: To avoid interference between the two
control devices, we advise against connecting a wall
thermostat to the stove if a remote control will also be
used as a thermostat.
Use only a 750 millivolt DC two-wire circuit wall
thermostat with this appliance. The thermostat should
be placed in the same room as the heater, typically 5
feet off the floor. Avoid drafty areas or any area that may
affect the accuracy of the thermostat.
The thermostat should be connected to the
terminal block using a minimum of 16 gauge wire with a
maximum length of 25 feet of wire.
Connect the two thermostat wire leads to the
terminals on the burner terminal block located on
the back of the control switch plate to the left of the
valve. Do not overtighten the connections. IT IS NOT
NECESSARY TO DISCONNECT ANY OTHER WIRES. See Fig.
11.1.
For thermostatic operation, set the On/Off/T-Stat
switch to the T-Stat position. Set the pilot mode to either
IPI or CPI.
At the thermostat, the two wires should be
connected to the two connection screws on the
thermostat base plate per the manufacturer's
instructions.
CAUTION:
LABEL ALL WIRES PRIOR TO DISCONNECTION WHEN
SERVICING THE CONTROLS. WIRING ERRORS CAN CAUSE
IMPROPER OR DANGEROUS OPERATION. ALWAYS VERIFY
PROPER OPERATION AFTER SERVICING THE APPLIANCE.
LAMP
IFC
BOARD
FAN
110 VAC
POWER
Figure 11.1. Accessory wiring diagram.
BURNER
SWITCH
ON
OFF
STAT
OPTIONAL
TERMINAL
THERMOSTAT
BLOCK
Fluted Panel Contents:
• Rear Panel ...................226210
• Left Side Panel .............226211
• Right Side Panel ......... 226212
INSTALL FUEL OR HIGH ALTITUDE CONVERSION
KITS BEFORE INSTALLING PANEL KITS.
THE PANELS ARE FRAGILE.
SUPPORT PANELS WITH BOTH HANDS.
HANDLE THE GLASS PANELS WITH THE COTTON GLOVES
PROVIDED TO MINIMIZE FINGERPRINTS. SKIN OILS ARE
DIFFICULT TO REMOVE FROM THE GLASS SURFACE.
This procedure applies to both kits.
ORIENT GLASS PANELS WITH THE
SMOOTH SIDE FACING OUT.
1. Place the Rear Panel flat against the back wall, resting
behind the small log peg on the rear shelf. When
installed, the two side panels will hold the rear in place.
2. The side panels rest on the shelves at each side of
the burner. Each panel is secured by a single Retainer
Bracket located at the inside front upper corner of the
firebox. Loosen the 10 mm retainer nut and turn the
bracket out to position the panel against the wall.
3. Turn the bracket head back in against the panel and
tighten the nut snug. See fig. 11.2.
Retainer
Bracket
Figure 11.2. Firebox panels installation.
139843_A GF 305 DV IPI 8/17
Reflective Black Glass Contents:
• Rear Panel ..................226087
• Left Side Panel .......... 226088
• Right Side Panel ....... 226089
• Cotton Gloves, 2
19
Hide quick links:
Advertisement
Table of Contents
