Battery Replacement - Transmitter; Battery Replacement - Jøtul GF 305 DV IPI Installation And Operation Instructions Manual

Figure 16.1. Use the Latch Tool to disengage both
latches on the glass frame.
Figure 16.2. Wrap the gasket around the glass panel.
Figure 16.3. Bend retainer tabs only enough to remove the
glass panel.
Remote Transmitter Battery
Replacement
The life-span of transmitter batteries depends upon
battery quality, the frequency of set point changes,
freqency of ignition call changes, etc.
When battery power is low, a Battery icon will appear on
the transmitter display before all power is lost. See fig.
15.20, page 35. The icon will disappear with installation of
three, 1.5 AAA fresh batteries.
NOTE: Avoid inadvertently pressing the thermostat
function key when replacing the batteries. Doing so
will turn off thermostatic functions. To restore that
function, re-install the batteries while again pressing
the thermostat key.
IFC Battery Replacement
A red LED on the IFC board indicates low battery power.
1. Switch Burner to OFF and disconnect power to the
stove.
2. The battery box is located behind the switch plate in
the controls compartment. See fig. 15.1. If a blower has
been installed, temporarily remove the switch plate to
access the box. Otherwise, the box is easily accessible
from behind the stove. Disengage the Velcro® pad
and depress the box cover to open.
3. Install four, 1.5v AA batteries and return box to the
compartment.
4. Reconnect power to the stove.
139843_A GF 305 DV IPI 8/17
37