Table of Contents
Advertisement
Versiv Cabling Certification Product Family
Users Manual
Button to manually control the output ports (
visual fault locator (
Micro-AB USB port: This USB port lets you connect the tester to a
PC so you can install software updates in the tester.
Headset jack
: Starts a test.
: Power key
: Press to use the headset to speak to the person at
the other end of the link. Press again to adjust the volume. To
turn off the talk function, hold down .
Connector for the AC adapter. The LED is red when the battery
charges, and green when the battery is fully charged. The LED is
yellow if the battery will not charge. See "Charge the Battery"
on page 11.
Decal with laser safety
information.
How to Remove and Install the Connector
Adapters
You can change the connector adapters on the input ports of the
modules to connect to SC, ST, LC, and FC fiber connectors. You
can remove the adapter on the output port to clean the fiber
endface in the port. See Figure 40.
98
).
and
) and the
Advertisement
Table of Contents
