Table of Contents
Advertisement
How to Do an OTDR Test
Figure 61 shows the equipment for OTDR tests.
To do an OTDR test
Make sure that the home screen shows the correct settings for
1
the job. If it is not necessary to use specific settings, set the
test type to Auto OTDR to make sure the results show all of
the events on the fiber.
Clean and inspect the connectors on the launch and tail cords
2
and the fiber to be tested.
Connect the tester to the link as shown in Figure 62, 63, or 64.
3
Tap TEST or press .
4
The tester shows a warning if there is an optical
signal on the fiber.
A
Versiv unit with OTDR module
installed
Launch and tail cords (match the
fiber to be tested)
Note
B
Figure 61. Equipment for OTDR Tests
Chapter 7: Use the OTDR
How to Do an OTDR Test
C
D
FI-1000 video probe with USB
connector
Fiber cleaning supplies
AC adapter with line cord
(optional)
E
GPU31.EPS
161
Advertisement
Table of Contents
