Configuration Parameters; Tuning Loop 1; Table 10-10 Set-Up Group - Tuning Loop 1 - Honeywell UDC3500 Product Manual

Modbus Read, Write and Override Parameters plus Exception Codes

10.7 Configuration Parameters

Overview
Listed on the next pages are the identifying codes for the parameters in the various Set-up
Groups in this instrument. Most of the parameters are configurable through the hosts.
Some are Read Only and are indicated as such and cannot be changed.
Reading or Writing
Do a Read or Write, depending on your requirements, using the identifying code and
format code listed in the tables. The range or selection available for each range is listed in
the tables.
10.7.1

Tuning Loop 1

Table 10-10 lists all the register addresses and ranges or selections for the function
parameters in the Set-up Group – Tuning Loop 1.
Parameter
Description
Gain #1 or PB
Note 1
Rate #1
Note 1
Reset #1
Note 1
Manual Reset
Gain #2 or PB #2
Note 1
Rate #2
Note 1
Reset #2
Note 1
Gain #3 or PB #3
Note 1
Rate #3
Note 1
Reset #3
Note 1
Gain #4 or PB #4
Note 1
358
Table 10-10 Set-up Group – Tuning Loop 1
Register
Address
ID Hex Decimal
1 0001 001
2 0002 002
3 0003 003
13 000D 013
4 0004 004
5 0005 005
6 0006 006
1 4001 16385
2 4002 16386
3 4003 16387
4 4004 16388
UDC3500 Universal Digital Controller Product Manual
Data Access
Type Enumerated Selection
FP R/W 0.001 to 1000 Gain
0.1 to 9999 PB
FP R/W 0.00 to 10.00
FP R/W 0.02 to 50.00
FP R/W –100 to +100
FP R/W 0.001 to 1000 Gain
0.1 to 9999 PB
FP R/W 0.00 to 10.00
FP R/W 0.02 to 50.00
FP R/W 0.001 to 1000 Gain
0.1 to 9999 PB
FP R/W 0.00 to 10.00
FP R/W 0.02 to 50.00
FP R/W 0.001 to 1000 Gain
0.1 to 9999 PB
Data Range or
3/07