Display Set Up Group; Table 3-27 Display Group Function Prompts - Honeywell UDC3500 Product Manual

3.27 Display Set Up Group

Introduction
This group includes selections for Decimal place, Units of temperature, Language and
Power frequency.
Function Prompts
Function Prompt
Lower Display
DECIMAL
DECIMAL2
TEMP UNIT
3/07

Table 3-27 DISPLAY Group Function Prompts

Selections or
Range of Setting
Upper Display
NONE
ONE
TWO
THREE
NONE
ONE
TWO
THREE
DEG F
DEG C
NONE
UDC3500 Universal Digital Controller Product Manual
Parameter
Definition
DECIMAL POINT LOCATION—This selection
determines where the decimal point appears in the
display.
NONE—No Decimal Place—fixed, no auto-ranging
ONE—One Place
TWO—Two Places
THREE—Three Places
ATTENTION Auto-ranging will occur for selections
of one, two or three decimal places. For example,
should the instrument be configured for two decimal
places and the PV exceeds 99.99, then the display
will change to a single decimal place so that values
of 100.0 and above can be shown.
DECIMAL POINT LOCATION FOR LOOP 2—This
selection determines where the decimal point
appears in the display for Loop 2.
NONE—No Decimal Place—fixed, no auto-ranging
ONE—One Place
TWO—Two Places
THREE—Three Places
ATTENTION Auto-ranging will occur for selections
of one, two, or three places.
TEMPERATURE UNITS FOR BOTH LOOPS—This
selection will affect the indication and operation.
DEG F—Degrees Fahrenheit – Degrees F
Annunciator lighted
DEG C—Degrees Centigrade – Degrees C
Annunciator lighted
NONE—No temperature annunciators lighted. Upper
and Lower Displays will show temperature in
Degrees Fahrenheit when inputs are configured for
Thermocouple or RTD types.
Configuration
177