Honeywell UDC3500 Product Manual page 175

Function Prompt
Lower Display
Digital Input
Prompts for
Healthwatch
Digital Input
Prompts for multiple
Set Point Programs
DIG1COMB
3/07
Selections or
Range of Setting
Upper Display
RESETT1
RESETT2
RESETT3
R ALL T
RESETC1
RESETC2
RESETC3
R ALL C
RALLTC
PROG LO
PROG HI
DISABLE
+PID2
+TO DIR
+TO SP2
+DIS AT
UDC3500 Universal Digital Controller Product Manual
Parameter
Definition
TIMER 1 will be reset when contact closes.
TIMER 2 will be reset when contact closes.
TIMER 3 will be reset when contact closes.
ALL TIMERS will be reset when contact closes.
COUNTER 1 will be reset when contact closes.
COUNTER 2 will be reset when contact closes.
COUNTER 3 will be reset when contact closes.
ALL COUNTERS will be reset when contact closes.
ALL TIMERS AND COUNTERS will be reset when
contact closes.
SETPOINT PROGRAM SELECTION—This feature
can be used to remotely select which Setpoint
Program is active when multiple Setpoint Programs
are enabled. Requires two Digital Inputs – one
configured as PROG HI and one configured as
PROG LO – in order to select all four programs.
ATTENTION These Digital Inputs force the SP
Program selection and override the keyboard.
PROG HI PROG LO
OFF OFF
OFF ON
ON OFF
ON ON
ATTENTION If only PROG LO is enabled, then
PROG HI is assumed to be "OFF". This is useful
when only SP Programs 1 and 2 are used as it
allows the user to select between these two SP
Programs with a single Digital Input.
DIGITAL INPUT 1 COMBINATION SELECTIONS—
This selection allows the specified function to occur
in addition to the one chosen for DIG IN 1.
DISABLE—Disables combination function.
PLUS PID2—Contact closure selects PID Set 2.
PLUS DIRECT ACTION—Contact closure selects
direct controller action.
PLUS SETPOINT 2—Contact closure puts the
controller to Local Setpoint 2.
PLUS DISABLE ADAPTIVE TUNE—Contact
closure disables Accutune process.
Configuration
Selected SP Program
SP Program #1
SP Program #2
SP Program #3
SP Program #4
159