Configuration
3.14 Display Parameters Set Up Group
Function
Prompt
Lower Display
DECIMAL
Control Loop 1 Decimal
Place
TEMPUNIT
Control Loop 1
Temperature Units
Power Frequency
PWR FREQ
Ratio for Input 2—Set from
RATIO 2
the front of the controller
Display Language
LANGUAGE
3.15 Calibration Group
The prompts used here are for field calibration purposes. Refer to Section 7 -
Calibration in manual #51-52-25-55 for complete information and instructions.
3.16 Status Group
The prompts used hare are read only. They are used to determine the reason for a
controller failure. Refer to Section 9 – Troubleshooting in manual #51-52-25-55 for
complete information.
38
Table 3-13 Display Group Function Prompts
Function
Name
UDC3300 Basic Model: DC330B User Manual
Selections or
Range of Setting
Upper Display
XXXX
XXX.X
XX.XX
X.XXX
ATTENTION
Auto-ranging will
occur to whichever decimal
place has been selected.
DEG F
DEG C
NONE
60 HZ
50 HZ
DISABL
ENABLE
ENGLIS
FRENCH
GERMAN
SPANIS
ITALAN
Factory
Setting
XXXX
NONE
60 HZ
DISABL
ENGLIS
5/00