Samsung DCS Programming Manual page 380

SAMSUNG
COMBINED SYSTEMS PROGRAMMING MANUAL
MMC: 837
FOR: OS500
Purpose: Sets SIP related parameters.
Dial Parameter
00
GATEWAY
CALL ID
01 CALLER ID
TYPE
05
DEFAULT DIL
NO.
06 UDP PORT :
TRUNK
07
UDP PORT :
PHONE
09 RE-TRANS.T1
TIME
10
RE-TRANS.T2
TIME
11 RE-TRANS.T4
TIME
12
GENERAL
RING TM
13
INVITE LING
TIME
14 PROVISIONAL
TIME
15
INV.NO RESP
TIME
16 GEN.NO
RESP TIME
17
REQ.RETRY
TIME
18 SIP SERVER
ENBLE
20
SIP SERVER
IP
Description
Sets the Caller ID for billing.
Sets the Caller ID type. The Caller ID type is displayed only when
it is identical to that sent by the caller.
Sets the call forward number for incoming calls that does not in-
clude the dial digit.
Sets the UDP port number when the other party is a C.O. line.
Sets the UDP port number when the other party is a phone.
When using unreliable transmission protocols such as UDP, re-
transmission is performed if there is no answer. RE-TRANS.T1
TIME is the initial retransmission interval defined in RFC2543.
The maximum retransmission interval defined in RFC 2543.
Defined for various purposes in RFC 2543. For example, in an unre-
liable protocol, this can be defined as the time that the User Agent
Server (USA) waits after receiving the ACK message.
In an unreliable transmission protocol it cannot be confirmed
whether the client received the last response from the server. In
this case, the server retransmits the response for this length of
time until the requested retransmission is received. For example,
the wait time after sending 200 OK for INFO.
In an unreliable transmission protocol, after the client sends ACK for
the INVITE Final Response, the client cannot confirm if the server
received the ACK message. The client waits for this length of time
after sending ACK for the Final Response.
After receiving the Provision Response, the User Agent waits for
this length of time until Timeout ends.
Before sending Cancel for the Invite Request, the User Agent
waits for this length of time.
Before sending Cancel for General Request, the User Agent
waits for this length of time.
After sending General Request, the User Agent waits for the
Final Response for this length of time.
Sets whether to use SIP Server (ENABLE/DISABLE)
Sets the IP address of the SIP Server.
MMC 837 (Page 1 of 2 )
MMC PROGRAMS
FEBRUARY 2004
SIP OPTIONS
Default
1234
ANI
500
05060
05070
500 mS
4000 mS
5000 mS
5000 mS
5000 mS
180000 mS
05000mS
05000mS
05000mS
DISABLE
0. 0. 0. 0