Setting Portable Power Monitor Ip Address; Switching To "Fun" Mode - Omron ZN-CTX21 User Manual

and must not overlap one another in the network. In the example above, Portable
Power Monitor Unit 2 is assigned with "192.168.0.21", the PC, "192.168.0.100",
changing the fourth value (segment) of the IP address of the monitor Unit 1, in order to
distinguish among the units connected.
・Set the same subnet mask value to the Portable Power Monitors and PC to be
connected in the network.
・To change the subnet mask, contact your network administrator. If the subnet mask is
changed from 255.255.255.0, the fourth segment of the IP addresses of the Portable
Power Monitors and PC in the network still must be distinguished from one another.
・The setting range of the individual segments of IP address and subnet mask is 0 to 255.

3.6.2 Setting Portable Power Monitor IP Address

This section explains the procedure to set the IP address for Portable Power Monitor Unit 2
(Example: Change the factory default "192.168.0.20" to "192.168.0.21").
Note
Refer to the sections below for details on messages displayed on the display unit and
operational key functions.
Refer to: 2.1 Display Unit and 2.2 Control Unit
(1)

Switching to "FUN" Mode

"FUN" mode should be entered for changing the IP address. Press the MODE key until the
"FUN" indicator at the right of the display starts blinking.
RUN Mode
FUN Mode
MODE Key
"FUN" Blinking
Twice
3-10
3. Check and Preparation
MODE Key
THR Mode
MODE Key