Table of Contents
Advertisement
3.6
Connecting to Network
Network settings are required on the Portable Power Monitors to be connected to a network.
Connect the LAN cables after completing the network settings on the Portable Power Monitor
units.
Important
・A full understanding of LAN is required to connect Portable Power Monitors to a network.
・Establish a dedicated LAN for connecting Portable Power Monitors to a network.
・Connection to an in-house network or an existing LAN requires caution, since specific
restrictions or rules may have been applied to the IP address management. Consult your
network administrator. In case that such a network is used, however, OMRON cannot
guarantee the performance of the Portable Power Monitors and the PC software.
・The measurement operation mode (MODE) still must be set to "NORM" if the IP address
and subnet masks settings use its default values. Also set the network function availability
(NET) to "ON". Network connection is not possible when "SLEEP" or "HISPD"
measurement mode (MODE) is entered.
3.6.1 Preparation
Define the IP addresses and subnet masks to use before establishing network connection.
Setting Example
Portable Power Monitor IP Address
PC IP Address
Subnet Mask
IP Address: 192.168.0.20
Subnet Mask: 255.255.255.0
Note
・Portable Power Monitors are assigned by the IP address: 192.168.0.20, and subnet
mask: 255.255.255.0 as the factory defaults.
・The IP addresses of Portable Power Monitors and the PC must be individually unique
(Unit 1): 192.168.0.20 (Factory default)
(Unit 2): 192.168.0.21
192.168.0.100
255.255.255.0 (Factory default)
LAN Cable
3-9
3. Check and Preparation
IP Address: 192.168.0.100
Subnet Mask: 255.255.255.0
W4S1-05C
check completed)
IP Address: 192.168.0.21
Subnet Mask: 255.255.255.0
(Operation
Advertisement
Table of Contents
