Table of Contents
Advertisement
(16)
Power Factor (PF)
Specifies the power factor of the circuit to be measured. The power factor refers to the ratio
of the real power to the apparent power in the circuit. The power factor varies depending on
the measurement target; however, it generally ranges from approx. 0.6 to 1.0. Since it is used
by the unit to convert a current value into a power value, it must be adjusted specifically on
individual measurement targets.
The range of selection (Numeric input):
0.01 to 1.00
Initial value: 0.8
(17)
Frequency (FREQ)
Used to select the power frequency at which the measurement target operates, according to
the power frequency used in your region or country. The unit uses the frequency to measure
current values. The correct frequency must be specified for measurement accuracy.
The range of selection (Options):
50Hz / 60Hz
Initial value: 50Hz
(18)
Initialization (INIT)
The unit initializes the setting values and restores the factory defaults (except for year,
month, day, hour and minute settings).
Operation:
Initialization starts at a long press of the SET/REC/STOP key and is completed when
"DONE" is displayed.
The unit resets itself and restarts when the MODE key is pressed to change the
operation mode.
4. Setting the Unit (Unit Operation)
4-14
Advertisement
Table of Contents
