5.3
Screen Transition in RUN Mode
Pressing the △ or ▽ key in RUN mode switches the display as shown below. Pressing
the MODE key changes the operation mode.
Momentary Power
Upper: No display.
Lower: Displays the momentary power (kW).
Individual CH Momentary Current
Upper: "CHx" is displayed. "x" changes according to the number of used channels
(USECH setting); e.g. "CH1", "CH2", or "CH3".
Lower: Displays the momentary power of the individual channel.
Elapsed Time (min., sec.)
Integrated Power
Upper: Shows the elapsed time from the measurement start. Displayed in "min., sec."
units during the first hour. After one hour has elapsed, it is displayed in "min.,
sec." and "day, hr." alternately.
When end trigger (ETRIG) is set, the remaining time up to recording stop is
displayed.
Lower: Displays the integrated power.
Note
The integrated value can be periodically reset to "0" by specifying the integrated
power reset interval (INTEG) in FUN mode.
Ave. Momentary Power
Upper: No display.
Lower: Sequentially displays the average (AVE), maximum (MAX) and minimum (MIN)
momentary power values. The values are reset together with the integrated
power value at the time specified by the integrated power reset interval (INTEG)
setting.
CHx
Max. Momentary Power
5. Measurement and Recording (Unit Operation)
Elapsed Time (day, hr.)
Integrated Power
5-2
Max. Momentary Power