Replacement Procedures; Lithium Battery; Bottom Panel - Sony PMW-EX3 Service Manual

2-2. Replacement Procedures

n
. When tightening screw, be sure to tighten it with the specified tightening torque.
. When reinstalling the removed tapping screw again, tighten it with slightly loose torque not to damage the threads of the
component side.
. If the tightening torque is not specified in a specific item, use the tightening torque as specified below.
± 0.02 N.m (1.8 ± 0.2 kgf.cm)
M2 (+) screw: 18 x 10 -2
± 0.07 N.m (5.3 ± 0.7 kgf.cm)
-2
M2.6 (+) screw: 53 x 10
± 0.01 N.m (8.0 ± 0.1 kgf.cm)
M3 (+) screw: 80 x 10 -2

2-2-1. Lithium Battery

1. Loosen the screw, and remove the button
battery lid.
2. Remove the lithium battery.
3. Reinstall the lithium battery by reversing the
steps of removal.

2-2-2. Bottom Panel

1. Remove the button battery lid. (Refer to
Section 2-2-1.)
2. Remove the four screws (M2 x 6), and
remove the bracket (tripod).
3. Remove the four screws (M2 x 4), and
remove bottom panel.
4. Reinstall the removed parts by reversing the
steps of removal.
2-2
Battery holder
Lithium battery
Lithium battery removal
Button battery lid
M2 x 4
(Black)
Lithium battery
Bottom panel
M2 x 4
(Black)
M2 x 6
(Black)
Bracket (tripod)
PMW-EX3