2-2-12. SWC-49 Board
1. Refer to Sections 2-2-5, and 2-2-9, and
disassemble the unit up to "Handle Assem-
bly" removal.
2. Disconnect the HN-348 board from the
connector (CN100) on the SWC-49 board.
3. Remove the two screws, and remove the top
panel cover.
4. Remove the two screws. Remove the top
panel earth bracket, the SWC-49 board and
the key top assembly (top panel).
5. Reinstall the removed parts by reversing the
steps of removal.
n
When reinstalling the removed tapping screw
again, refer to note of section "2-2. Replace-
ment Procedures."
2-14
Top panel cover
SWC-49
board
CN100
Key top assembly
(top panel)
Top panel cover
HN-348
board
M2 x 4 (Silver)
Tapping
2 x 5 (Black)
Top panel earth bracket
SWC-49 board
PMW-EX3