Sony PMW-EX3 Service Manual page 36

11. Reinstall the removed parts by reversing
steps 7 to 10.
n
Arrange the extra length of the harness
coming from the connector (CN2) of the
LED-469 board as described in the illustra-
tion.
12. Reinstall each part by reversing steps 2 to 6.
13. Connect the harness to the connector (CN1)
on the HP-144 board, and route the harness
between the rear shoe bracket and the HP
jack. Then route the harness along the
underside of the HP jack.
14. Refer to Section 2-2-5 and reinstall the
"Handle Top Cover Assembly".
2-10
Extra length
of harness
CN2 Arrange the extra length of the harness
so that it is completely housed inside
the space in the deep end and
should not come outside the space.
CN1
Rear shoe bracket
HP-144 board
HP jack
PMW-EX3