Board, Hn-349 Board - Sony PMW-EX3 Service Manual

2-2-8. AXM-36 Board, HN-349 Board
1. Refer to Section 2-2-5 and remove the
"Handle Top Cover Assembly".
2. Remove the rubber switch key.
3. Remove the two screws (B2.6 x 6 : Silver),
and remove the out microphone bracket.
4. Disconnect the HN-349 board from the
connector (CN5) on the KSW-54 board.
5. Remove the four screws (P2.6 x 6 : Black),
and remove the AXM-36 board in the
direction of the arrow.
6. Disconnect the HN-349 board from the
connector (CN3) on the AXM-36 board.
7. Reinstall the removed parts by reversing the
steps of removal.
n
When installing the screws that were re-
moved in step 5, tighten them with the
specified tightening torque.
Tapping P2.6 x 6 tightening torque:
± 0.15 N.m (8.0 ± 1.5 kgf.cm)
80 x 10 -2
2-8
B2.6 x 6
(Silver)
Out microphone
bracket
HN-349 board
AXM-36 board
P2.6 x 6
(Black)
P2.6 x 6
(Black)
Rubber switch key
CN3
KSW-54 board
CN5
PMW-EX3