Attaching The Emi-Prevention Components For Uc Model; Inside Panel - Sony PMW-EX3 Service Manual

2-3. Attaching the EMI-Prevention Components for UC Model

Serial No. (UC): 100001 to 101880 and 101889 to 102150

2-3-1. Inside Panel

Required components
. Ferrite core: 1-500-945-11 x 1
. Tape (LED): 1-116-574-01 x 1
Procedure
1. Remove the inside panel assembly. (Refer to
Section 2-2-13.)
2. Remove the two screws, and disconnect the
HN-343 board from the connector on the
SWC-48 board.
3. Pass the HN-343 board through a ferrite core,
and connect it to the connector on the SWC-
48 board.
4. Pass the HN-343 board through a ferrite core,
and connect it to the connector on the SWC-
48 board.
5. Assemble the removed parts by reversing
steps of removal. (Refer to Section 2-2-13.)
2-42
Location of the prevention components
Ferrite core
Tape (LED)
M2 x 4
(Silver)
Inside panel
HN-343 board
Ferrite core
SWC-48 board
Tape (LED)
PMW-EX3