Sw-1411 Board; Outside Panel Sub Assembly - Sony PMW-EX3 Service Manual

2-2-20. SW-1411 Board

1. Refer to Sections from 2-2-1 to 2-2-3, 2-2-5,
2-2-9, 2-2-13, 2-2-18 and 2-2-19, and
disassemble the unit up to "SWC-48 Board"
removal.
2. Disconnect the harness from the connector
(CN400) on the SW-1411 board.
3. Remove the four screws, and remove the
SW-1411 board.
4. Remove the two light interception spacers
from the inside panel assembly (1).
5. Reinstall the removed parts by reversing the
steps of removal.
n
When reinstalling the removed tapping screw
again, refer to note of section "2-2. Replace-
ment Procedures."

2-2-21. Outside Panel Sub Assembly

1. Refer to Sections from 2-2-1 to 2-2-3, 2-2-5
and 2-2-9, and disassemble the unit up to
"Handle Assembly" removal.
2. Remove the five screws (silver) and the
screw (black). Disengage the six protrusions
of the outside panel sub assembly from the
corresponding six dowels, and remove the
outside panel sub assembly in the direction of
the arrow.
3. Reinstall the removed parts by reversing the
steps of removal.
n
When installing the outside panel sub
assembly (to be abbreviated as "O-assembly"
hereafter), stand the unit and the O-assembly
vertically. Then, move the O-assembly
toward the unit in parallel with the unit, and
install the O-assembly.
Do not install the O-assembly at an angle.
PMW-EX3
Light interception
Harness
spacers
CN400
Tapping
2 x 5
(Black)
Main unit
M2 x 4
(Black)
Inside panel assembly (1)
SW-1411 board
Outside panel sub
assembly
M2 x 4
(Silver)
M2 x 4
(Silver)
Protrusion of outside
panel sub assembly
Dowel
2-23