Handle - Sony PMW-EX3 Service Manual

2-3-4. Handle

Required components
. Gasket (VF): 4-119-228-01 x 1
. Tape (13 x 50): 4-119-886-01 x 1
. EMC sheet: 4-121-111-01 x 3
Procedure
1. Remove the handle assembly. (Refer to
Section 2-2-9.)
2. Spread out the wires of the coaxial cable with
connector so the wires are not overlapped.
Attach the EMC sheet at the position shown
in the illustration.
n
Do not attach the EMC sheet with the wires
of the coaxial cable with connector bundled.
3. Wrap the tape (13 x 50) around the EMC
sheet so the entire EMC sheet that was
attached in step 2 is covered by the tape.
PMW-EX3
Location of the prevention components
EMC sheet,
Tape (13 x 50)
1
Bundle
NG
2
Valley fold
Binding tape
1 to 3 mm
Align the ends.
EMC sheet
Gasket (VF)
Coaxial cable
with connectors
Spread
OK
3
Tape (13 x 50)
Align the ends.
2-45