Board - Sony PMW-EX3 Service Manual

2-2-18. HN-344 Board
1. Refer to Sections from 2-2-1 to 2-2-3, 2-2-5,
2-2-9 and 2-2-13, and disassemble the unit up
to "Inside Panel Assembly" removal.
2. Disconnect the SWC-48 board from the
connector (CN300) on the SW-1410 board.
3. Remove the four screws, and remove the
inside panel assembly (1).
4. Disengage the two claws, and remove the CN
holder.
5. Disconnect the HN-344 board connector
(CN101) from the SWC-48 board connector
(CN100).
6. Reinstall the removed parts by reversing the
steps of removal.
n
When reinstalling the removed tapping screw
again, refer to note of section "2-2. Replace-
ment Procedures."
2-20
SW-1410

board

CN300
Inside panel assembly (1)
Tapping
2 x 5
(Black)
SWC-48 board
SWC-48 board
CN100
HN-344 board
CN101
Inside panel assembly (2)
CN holder
Claws
PMW-EX3