Flexible Flat Cable - Sony PMW-EX3 Service Manual

2-4-3. Flexible Flat Cable

Required components
. Tape (13 x 50): 4-119-886-01 x 3
. EMC sheet: 4-121-111-01 x 3
Procedure
1. Remove the outside panel sub assembly.
(Refer to Section 2-2-21.)
2. Disconnect the flexible flat cable from the
connector on the DPR-289A board.
3. Attach the EMC sheet at the position shown
in the illustration.
4. Wrap the tape (13 x 50) around the EMC
sheet so the entire EMC sheet that was
attached in step 3 is covered by the tape.
5. Connect the flexible flat cable to the connec-
tor on the DPR-289A board.
6. Assemble the removed parts by reversing
steps of removal. (Refer to Section 2-2-21.)
2-52
Location of the prevention components
EMC sheet,
Tape (13 x 50)
DPR-289A board
1
EMC sheet
Align the
7 to 10 mm
end surface.
Wrap the tape.
Flexible flat cable (30 core)
2
Wrap the tape.
Tape (13 x 50)
PMW-EX3