Sony PMW-EX3 Service Manual page 38

7. Tighten the lock screw with specified torque.
Lock screw tightening torque:
± 0.02 N.m (9.5 ± 0.2 kgf.cm)
95 x 10 -2
8. Install the lock lever to the lock screw so that
protrusion of the lock lever is positioned next
to protrusion of the arm case.
9. Apply a small amount of the thread locking
adhesive agent to the screw tip of the two
screws a.
10. While the state established by step 8 is
maintained, attach the two screws a.
Screw a tightening torque:
± 0.05 N.m (5.0 ± 0.5 kgf.cm)
-2
50 x 10
n
Turn the lock lever fully counterclockwise
and confirm that the VF assembly can move
smoothly in the directions of A and B as
shown by the arrow.
11. Reinstall each part by reversing step 1.
2-12
Protrusions are next
to each other.
Protrusions are next
to each other.
Lock screw
Screws a
VF assembly
[A]
[B]
Lock lever
PMW-EX3