The Ethernet Lan Led Is Not Lit - NETGEAR WNAP320 Reference Manual

ProSafe Wireless-N Access Point WNAP320 Reference Manual

The Ethernet LAN LED is not lit.

There is a hardware connection problem.Check these items:
Make sure that the cable connectors are securely plugged in at the access point and the
•
network device (hub, switch, or router). A switch, hub, or router must be installed between
the access point and the Ethernet LAN or broadband modem.
The LAN LED does not light if the link is 10 Mbps. In such cases, the LAN LED will still
•
blink if there is activity.
Make sure that the connected device is turned on.
•
Make sure that the correct cable is used. Use a standard Category 5 Ethernet patch
•
cable. If the network device has Auto Uplink™ (MDI/MDIX) ports, you can use either a
crossover cable or a normal patch cable.
Chapter 5. Troubleshooting and Debugging | 47