Remote Console
Remote Console configuration features are located under the Maintenance, Remote
Management, Remote Console. Enter the following information in the Remote Console
screen, as shown in
Secure Shell (SSH). If set to Enable, the wireless access point will allow remote access
•
only through Secure Shell and Secure Telnet. The default is Enable.
Telnet. If set to Enable, the wireless access point will allow remote access through
•
Telnet. The default is Disable. If Telnet is enabled and the access point is accessed
using a browser, the Telnet access will be disconnected.
Figure 2.
Click Apply.
4.
Management Using Telnet
Open a secure Telnet session from your computer to the access point. The screen
1.
shown in
Figure 3,
22 |
Chapter 3. Management
ProSafe Wireless-N Access Point WNAP320 Reference Manual
:
Figure 2,
should display.