NETGEAR WNAP320 Reference Manual page 32

adjacent access points is 5 channels (for example, use channels 1 and 6, or 6 and
11).
– In "Infrastructure" mode, wireless stations normally scan all channels, looking for an access point.
If more than one access point can be used, the one with the strongest signal is used. This can only
happen when the various access points are using the same SSID.
See Related Documents in Appendix A for links to more information on configuring
wireless channels.
From the Data Rate pull-down menu, select the transmit data rate of the wireless network.
6.
The default is Best.
From the Output Power pull-down menu, set the transmit signal strength of the access
7.
point. The options are full, half, quarter, eighth, and min. Decrease the transmit power if
more than one AP is collocated using the same channel frequency. The default is Full.
Click Apply to save your wireless settings.
8.
From the main menu under Security, select Security Profile Settings.
9.
32 | Chapter 2. Installation and Configuration
ProSafe Wireless-N Access Point WNAP320 Reference Manual