Factory Default Settings - NETGEAR WNAP320 Reference Manual

ProSafe Wireless-N Access Point WNAP320 Reference Manual

Factory Default Settings

You can use the restore settings button located on the rear of your device to reset all settings
to their factory defaults. This is called a hard reset.
To perform a hard reset, push and hold the restore settings button for approximately 5
•
seconds (until the Test LED blinks rapidly). Your device will return to the factory
configuration settings shown in
Pressing the restoresettings button for a shorter period of time simply causes your device
•
to reboot.
Table 3. Access Point Default Configuration Settings
Feature
AP Login
User Login URL
User Name (case-sensitive)
Login Password (case-sensitive)
Ethernet Connection
Static IP Address
Ethernet MAC Address
Port Speed
Local Network (LAN)
Lan IP
Subnet Mask
Gateway Address
DHCP Server
DHCP Client
Time Zone
Time Zone Adjusted for Daylight Saving
Time
SNMP
Spanning Tree Protocol
Secure Telnet
Wireless
Table 3.
Description
192.168.0.100
admin
password
192.168.0.210
See bottom label.
10/100/1000
192.168.0.100
255.255.255.0
0.0.0.0
Disabled
Disabled
USA-Pacific
Disabled
Enabled, but trap forwarding disabled
Disabled
Enabled
Appendix A. Supplemental Information | 55