ProSafe Wireless-N Access Point WNAP320 Reference Manual
Figure 10.
Verify the following parameters for all access points:
3.
The access points are configured to operate in the same LAN network address range
•
as the LAN devices.
All access points must be on the same LAN. That is, all the LAN IP addresses of the
•
access points must be in the same network.
If you are using DHCP, all access points should be set to Obtain an IP address
•
automatically (DHCP Client) in the IP Address Source portion of the Basic Settings
screen.
All ProSafe Wireless Access Points use the same SSID, channel, authentication
•
mode, if any, and encryption.
Verify connectivity across the LANs.
4.
A computer on any LAN segment should be able to connect to the Internet or share files
and printers with any other PCs or servers connected to any of the three WLAN
segments.
Click Apply to save your settings.
5.
You can extend repeating by adding up to two additional
Note:
WNAP320s configured in Repeater mode. However, since repeater
configurations communicate in half-duplex mode, the bandwidth
Chapter 4. Advanced Configuration
| 33