I Cannot Connect To The Wnap320 To Configure It - NETGEAR WNAP320 Reference Manual

ProSafe Wireless-N Access Point WNAP320 Reference Manual

I cannot connect to the WNAP320 to configure it.

Check these items:
The WNAP320 is installed correctly, LAN connections are OK, and it is powered on.
•
Check that the LAN port LED is green to verify that the Ethernet connection is OK.
The default configuration of the WNAP320 is for a static IP address of 192.168.0.100 and
•
a subnet mask of 255.255.255.0 with DHCP disabled. Make sure that your network
configuration settings are correct.
If you are using the NetBIOS name of the WNAP320 to connect, ensure that your
•
computer and the WNAP320 are on the same network segment or that there is a WINS
server on your network.
If your computer is set to "Obtain an IP address automatically" (DHCP client), restart it.
•
If your computer uses a fixed (static) IP address, ensure that it is using an IP address in
•
the range of the WNAP320. The default IP address is 192.168.0.100, and the default
subnet mask is 255.255.255.0.
Chapter 5. Troubleshooting and Debugging | 49