NETGEAR WNAP320 Reference Manual page 21

ProSafe Wireless-N Access Point WNAP320 Reference Manual
Figure 5.
Fill in the IP address fields of the access point. (See the online help for more information
4.
about how to specify the settings on this screen).
DHCP Client. By default, the Dynamic Host Configuration Protocol (DHCP) client is
•
disabled. If you have a DHCP server on your LAN and you enable DHCP, the wireless
access point will get its IP address, subnet mask, and default gateway settings
automatically from the DHCP server on your network when you connect the access
point to your LAN.
IP Address. Enter the IP Address of your product family.The default IP address is
•
192.168.0.100. To change it, enter an unused IP address from the address range
used on your LAN; or enable DHCP.
IP Subnet Mask. The Access Point will automatically calculate the subnet mask
•
based on the IP address that you assign. Otherwise, you can use 255.255.255.0 (the
default) as the subnet mask.
Default Gateway. Enter the IP address of the gateway for your LAN. For more
•
complex networks, enter the address of the router for the network segment to which
the product family is connected. The default is 0.0.0.0.
Primary DNS Servers. The access point will use this IP address as the primary
•
Domain Name Server used by stations on your LAN. The default is 0.0.0.0.
Secondary DNS Servers. The access point will use this IP address as the secondary
•
Domain Name Server used by stations on your LAN. The default is 0.0.0.0.
Click Apply to save your Basic IP settings.
5.
Chapter 2. Installation and Configuration | 21