Troubleshooting; No Lights Are Lit On The Access Point; The Ethernet Lan Light Is Not Lit - NETGEAR WG602 - 54 Mbps Wireless Access Point Reference Manual

This chapter provides information about troubleshooting your NETGEAR WG602v3 54 Mbps
Wireless Access Point. After each problem description, instructions are given to help you diagnose
and solve the problem. For the common problems listed, go to the section indicated.
• Is the WG602v3 on?
• Have I connected the wireless access point correctly?
Go to "Basic Setup and Installation" on page
• I cannot remember the wireless access point's configuration password.
Go to "Changing the Administrator Password" on page
Note: For up-to-date WG602v3 installation details and troubleshooting guidance visit
http://kbserver.netgear.com/products/WG602v3.asp.

Troubleshooting

If you have trouble setting up your WG602v3, check the tips below.

No lights are lit on the access point.

The access point has no power.
• Make sure the power cord is connected to the access point and plugged in to a working power
outlet or power strip.
• Make sure you are using the correct NETGEAR power adapter supplied with your access
point.

The Ethernet LAN light is not lit.

There is a hardware connection problem.
2-2.
3-6.
v1.0, August 2006
Chapter 5
Troubleshooting
5-1