Mc_Movejog; Mc_Movejog: Move Axes In Jog Mode V2 - Siemens SIMATIC S7-1500 Function Manual

Instructions
11.1 S7-1500 Motion Control V2
See also
Error ID (Page 386)
11.1.3

MC_MoveJog

11.1.3.1

MC_MoveJog: Move axes in jog mode V2

Description
With the Motion Control instruction "MC_MoveJog", you can move an axis in jog mode.
Dynamic behavior during movement is defined with the parameters "Velocity", "Jerk",
"Acceleration" and "Deceleration".
● Positioning axis/synchronous axis:
● Speed axis:
A speed is specified at the "Velocity" parameter.
Applies to
● Synchronous axis
● Positioning axis
● Speed axis
Requirement
● The technology object has been configured correctly.
● The technology object is enabled.
244
A velocity is specified in the "Velocity" parameter.
S7-1500 Motion Control V13 Update 3
Function Manual, 07/2014, A5E03879256-AC